50W Power Amplifier circuit based on STK-1050

Tags

Here is one of the circuit diagram of a power amplifier with the STK1050 single power chip which is supported by several components that make a better sound output. This amplifier is a single output amplifier, so if you want a stereo amplifier, then you must make a similar circuit.

50W Power Amplifier with STK-1050 circuit diagram

STK-1050 Features:
STK1050 has some features that make it superior and good for your audio amplifier.

  1. Does not require externally connected emitter resistors.
  2. Values of emitter resistors have carefully been reviewed to provide superior characteristics.
  • Better supply voltage utilization permits designing power supply voltage that are about 0.7V (for RL=4ohms) lower than those required for previous DPP models.
  • Maximum allowable power consumption for each resistor is 5W or higher, permitting accomodation for all loads.
  • Peak allowable current is 18A or more, providing an ample margin even for peak currents under when short circuited or similar emergencies.
  • In particular, maximum output 4 ohms have been enormously improved.

  1. Use of emitter resistors facilitates meeting different safety standards and designing PCBs
  2. Mutual interferences in the high-frequency range caused by layout of externally connected emitter resistors no longer exist. This facilitates lower distortion factors.
  3. Pins are used for emitter resistor output terminals that were not conected in previous DPPs. All other terminals remain uncharged; there is no need for major circuit board changes.

Download STK-1050 datasheet