35W Power Amplifier Circuit using STK082

Tags
The following is the schematic diagram of 35W power audio amplifier. Built based on power-amp IC of STK082, this circuit will give great audio output for your home audio system.
35W Power Amplifier Circuit using STK082


Download the STK082 datasheet

Easy LED Flasher Schematic

Here the schematic diagram of Easy LED Flasher circuit:
Easy LED Flasher Schematic


Parts List:

R1 = 10M ohm
R2 = 1K – 100K ohm
R3 = 470 ohm
C1 = 0.47μF – 10μF/25V
D1 = 1N914
Q1 = 2N3904
Q2 = 2N3906
Led = High Brightness Red LED


This circuit will flash a bright or high-brightness red LED (5000+ mcd). Very good for fake car alarm or other attention getting device. Part values are not significant, test something else to start with from your junkbox.Certainly, the 470 ohm resistor (R3) determines the LED's brightness and limits the current supply to around 20mA. R3 value of 390 ohm may also be applied as a save value.

If you decide to go using a green or yellow led, which take more current, you might want to change the 470 ohm with an suitable value. Flash speed is established by R2 and C1 and is roughly three time constants (3*R2*C1). R1 provides bias to Q1 which ought to be small enough not to saturate Q2 with the capacitor disconnected. When the circuit doesn't oscillate, R1 may be very low or R2 too high. D1 allows for highter duty cycle operation and limits the feedback at the base of Q1 to -0.7 volts. D1 might be ommited for low supply power like 6 - 9V and low duy cycle operation.